Orijinalini görmek için tıklayınız : Fn2 typer saat sıfırlaması
Araç 2008 fn2 typer, harici double teyp takılı.Direksiyon kumandası aparatıda var, sırf direksiyon kumandası çalışsın diye dandik double'dan pioneer double geçiş yaptım. Ama her kontak açılıp kapandığında saat ve tarihi sıfırlıyor. Aynı zamanda direksiyondaki kanal arama tuşu ile ses açıyor, ses açma tuşu geçiş yapıyor. Bir inceliğimi var acaba bilen varmıdır?
deeperblack
16-07-2021, 23:47
Ben zamanında orj. teybini torpido içine taşımıştım sırf bu nedenle. Her açılıp kapandığında sıfırlanıyorsa montajla ligili bir sorun olabilir.
Y. dışında direksiyondaki mode tuşu ile olduğu söyleniyor birkaç forumda. Bir deneyin isterseniz.
Sadece saat mı sıfırlanıyor
radyo kanalları ayarlar da sıfırlanıyor mu
Ben zamanında orj. teybini torpido içine taşımıştım sırf bu nedenle. Her açılıp kapandığında sıfırlanıyorsa montajla ligili bir sorun olabilir.
Y. dışında direksiyondaki mode tuşu ile olduğu söyleniyor birkaç forumda. Bir deneyin isterseniz.
Direksiyonu aktif hala getirdim ama ayarlasamda genede gidiyor star stop sonrası.
Sadece saat mı sıfırlanıyor
radyo kanalları ayarlar da sıfırlanıyor mu
sadece saat abi
Saat hafızası için teyp içinde bir pil veya kondansatör olabilir mi?
Saat hafızası için teyp içinde bir pil veya kondansatör olabilir mi?
aklıma geldi ama öyle bir pil varsa bilen söylerse sevinirim :)
Teybin marka modelini tam yaz, netten bakalım
Sarı renkli memory cable'da (hafızayı sürekli besleyen kablo) kontak açık-kapalı fark etmeksizin 12 V olmalı diyor internet.
Kablolara bakabildin mi sen?
How to check stereo and fuse - YouTube (https://www.youtube.com/watch?v=tUvswSOR78E&t=2s)
How To Fix Pioneer Car Stereo That Keeps Resetting Itself - How To Install Car Audio Systems (https://how-to-install-car-audio-systems.blogspot.com/2016/07/how-to-fix-pioneer-car-stereo-that.html) sarı ve kırmızı kablolar önemli imiş, bazen karıştırılabiliyormuş.
Malfunctioned Memory Wire
If your car stereo keeps falling back to the default setting whenever you start the engine, it also might be due to a malfunctioned memory wire.
A memory wire is a yellow-colored lead in your stereo’s wire harness. It is different from other head unit wires because it contains power all the time, even when your car is standing stationary with its engine off.
This wire provides power to the clock of the head unit and the radio frequency setter. It is called a “memory” wire because it saves the station (radio frequency) memory and plays the same frequency that you set the last time whenever you turn on the stereo again.
If the reset happens primarily when you start your car, you should try replacing the memory wire and see if the problem goes away. If you can’t detect any issue with the memory with a visual inspection, check it for its voltage reading through a multi-meter. A perfectly working memory wire will give you approximately 12V reading when the engine is off.
Kötü olan ise teypte sorun olması imiş:
A Malfunctioned Head Unit
Your stereo might still auto-resets even when all the wires and connectors are installed properly, the fuse is working fine, and there is no issue with the memory wire. It’s a sign that your head unit has developed some internal circuitry issues. You have to consult an expert audio enthusiast to resolve this complex head unit issue. In some cases, you might have to replace the head unit altogether.
However, always make the final call regarding the head unit replacement when you are 100% confident about its irreparable malfunctioning. Car head unit replacement is an expensive affair and might require extensive work. Therefore, due diligence is very important before declaring it broken and replacing it.
Sarı renkli memory cable'da (hafızayı sürekli besleyen kablo) kontak açık-kapalı fark etmeksizin 12 V olmalı diyor internet.
Kablolara bakabildin mi sen?
How to check stereo and fuse - YouTube (https://www.youtube.com/watch?v=tUvswSOR78E&t=2s)
How To Fix Pioneer Car Stereo That Keeps Resetting Itself - How To Install Car Audio Systems (https://how-to-install-car-audio-systems.blogspot.com/2016/07/how-to-fix-pioneer-car-stereo-that.html) sarı ve kırmızı kablolar önemli imiş, bazen karıştırılabiliyormuş.
Malfunctioned Memory Wire
If your car stereo keeps falling back to the default setting whenever you start the engine, it also might be due to a malfunctioned memory wire.
A memory wire is a yellow-colored lead in your stereo’s wire harness. It is different from other head unit wires because it contains power all the time, even when your car is standing stationary with its engine off.
This wire provides power to the clock of the head unit and the radio frequency setter. It is called a “memory” wire because it saves the station (radio frequency) memory and plays the same frequency that you set the last time whenever you turn on the stereo again.
If the reset happens primarily when you start your car, you should try replacing the memory wire and see if the problem goes away. If you can’t detect any issue with the memory with a visual inspection, check it for its voltage reading through a multi-meter. A perfectly working memory wire will give you approximately 12V reading when the engine is off.
Kötü olan ise teypte sorun olması imiş:
A Malfunctioned Head Unit
Your stereo might still auto-resets even when all the wires and connectors are installed properly, the fuse is working fine, and there is no issue with the memory wire. It’s a sign that your head unit has developed some internal circuitry issues. You have to consult an expert audio enthusiast to resolve this complex head unit issue. In some cases, you might have to replace the head unit altogether.
However, always make the final call regarding the head unit replacement when you are 100% confident about its irreparable malfunctioning. Car head unit replacement is an expensive affair and might require extensive work. Therefore, due diligence is very important before declaring it broken and replacing it.
Kabloları bi kontrol edeyim tekrardan. Olayı tam olarak şöyle söyleyim medion marka double teyp vardı aracımda sw girişi olmadıgı için direksiyon kumandası calısmıyordu. Pioneer ı daha dün aldım medion varkende saat tarih sıfırlıyordu.
burak1533
17-07-2021, 19:10
Hafıza kablosu ve kontak açılınca elektrik gelen + kablosunun yerini değiştirmeyi deneyebilirsiniz başıma gelmişti aynı sorun.
deeperblack
17-07-2021, 22:11
Kırmızı kablo direk +
Sarı kablo kontak
Bağlantı sorunu var demektir. Ben saat gidiyo dediğinde üst ekrandaki saati zannettim. Meğer senin teybin saat gidiyormuş.
Kırmızı kablo direk +
Sarı kablo kontak
Bağlantı sorunu var demektir. Ben saat gidiyo dediğinde üst ekrandaki saati zannettim. Meğer senin teybin saat gidiyormuş.
Teybin saati değil abi, tamamen klima panelinde saat sıfırlanıyor. şimdi eke resim ekleyeceğim arap saçı gibi işin içinden çıkmaya calısıyorum
Şimdi şöyle bi kabloları atayım, net sıkıntım şudur.
1- Klima panelindeki saat her kontakda sıfırlıyor.
2-Direksiyon kumandası calısıyor ama, ch yazan ile ses açıyor vol yazan ile usb-radyo-bt arası geçiş yapıyor.
https://i.hizliresim.com/2qh8s7u.jpg (https://www.hizliresim.com/2qh8s7u)
https://i.hizliresim.com/e92ald9.jpg (https://www.hizliresim.com/e92ald9)
https://i.hizliresim.com/t6bs8in.jpg (https://www.hizliresim.com/t6bs8in)
Arkadaşlar sorunu çözdüm başına gelen olursa diye yazıyorum. Tamamen bağlantı hatası ile ilgili bir sorun.
-Eski sahipleri saati kontağa bağlamışlar ondan dolayı her açılıp kapanmadı sıfırlıyordu. Şu an saati + uça bağlayıp sorunu çözdüm.
-Kumandada ters bağlanmış onun kablolarını ayırıp tekrardan kontrol ede ede halllettim.
-Bu arada saati ayarlamak için ( Direksiyon kumandası modülü olması şart ) Mode tuşuna basılı tutuyorsunuz, Ardından Ch tuşu ile saat ve dakika arasında geçiş yapıyorsunuz, ardından volume tuşu ile ileriye veya geriye alıyorsunuz. Tekrar mode tuşuna basılı tutarak ayaları kayıt ediyorsunuz.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.