PDA

Orijinalini görmek için tıklayınız : White Fear



Tholl-ga
26-06-2007, 22:48
http://smdandb2.smugmug.com/photos/166131447-M.jpg
http://smdandb2.smugmug.com/photos/166131826-M.jpg
http://www.iwsti.com/blogs/uploads/0/007STI/467.jpg
http://cuento.smugmug.com/photos/165935910-M.jpg
http://i37.photobucket.com/albums/e66/007-STi/Paintedcageplusdualscrollmanifold01.jpg
http://www.iwsti.com/blogs/uploads/0/007STI/471.jpg
http://i37.photobucket.com/albums/e66/007-STi/Paintedcage001.jpg

Mod list:

Engine and Power stuff:

-Locally built 2.6L (very knowledgeable builder that has been doing Subaru aircraft and sand rail engines for years)
-Darton Sleeves
-102.5mm CP pistons "8.5:1" (I would have like a little higher CR but was to impatient)

-Cobb Rods
-cosworth rod and main bearings
-factory crank (very excited to see how far the factory crank can be revved with a good oil supply???)
-gutted factory oil pump (using a external Peterson WET/VAC oil pump for oil supply)
-engine deck has been stainless steel O ringed to work with a SCE copper head gasket. (Lots of boost!!!)
-DPR stage 5 cams
-Heads have seen a lot of time on the flow bench (313 CFM @ .45 lift)
-2.5 mm over sized Ferrara intake valves (Sorry to say the AVCS had to go, the valves would have touched each other.
-1.5mm over sized exhaust valves
-spark plug seats have been machined down so a standard 3/4" reach NGK plug can be used (allot more heat range options)
-Ported TGV
-Cosworth 14mm head studs
-14mm studs that hold the block halves together
-Custom built 4" turbo back exhaust
-custom built dual scroll up-pipe
-Garrett GT4202R
-Twin Tial 44mm wastegate
-Tial BOV
-modified twin scroll APS exhaust manifold
-Custom built large plenum intake manifold w/velocity stacks and long tapered runners.
-Infinity Q45 90mm throttle body
-Three intake walbro 255's (each 255 has a -6AN line that is fed to a fuel block and them a -10AN fuel line is ran to the engine bay were it feeds two -10AN fuel rails
-1600cc top feed low impedance fuel injectors
--10AN Aeromotive FPR
-Hydra EMS (Phil is the best!!!)


Tranny power delivery:
-ATS triple carbon clutch
-As for the rest of the tranny and the power delivery items, I ** going to leave them stock because I ** curious as to see at what power level these items start breaking.


Suspension Chassis, braking:
-Tein Flex Coil over’s
-Cusco rear sway bar
-Cusco front strut tower brace
-Carbon Cusco rear strut tower brace
-Custom cromolly cage to be installed in the short future
-factory STi braking system.


Interior:
- As little as possible
- Sparco Evo L seats
- Defi gauge's
- Radio??? “Radio who needs a stinkin radio”



Exterior:
-Street--- Volk CE28N’s w/ 255/35-18
-Track--- PRODRIVE GC06H 17X8 w/ 275/40-17 mickey thompson ET streets.
-No wing
-WRX hood scoop

bu de videosu (http://videos.streetfire.net/video/dc481e6f-e575-4918-b996-995701244f7f.htm)

cem
26-06-2007, 22:51
GT4202R iyidir:angel:

yiit
26-06-2007, 22:54
nası şişio ya çok ii :Deli:

efe-E
26-06-2007, 22:56
ellerine sağlık tolga abim.baya iyi bir setup'ı var.1600cc benzin pompası enjektörüne de kısaca "oha" demek istiyorum.gerçi siteden bir arkadaşımızda da var ama :P

genelde yarış tipi hazırlanmış subaru'larda Hydra EMS kullanıldığı dikkatimi çekti.
Acaba üzerinde Apexi Power FC'den veya Motec'ten daha fazla oynanabilitesi olduğu için mi yoksa ikisine göre fiyatı daha makul olduğu için mi?

Tholl-ga
26-06-2007, 22:58
baytar Ecu ye sorucan onu :D

MiaMi
26-06-2007, 23:10
Doluyorr demekki.

SkY
26-06-2007, 23:57
çok güzel hem motoru hemde rengiyle..

emreekin
27-06-2007, 01:37
ohaaaaaa sesler çok ilginç yanlız......iyi dinleyin..:D :D :D :D :D :D :D

M_PROJECT
27-06-2007, 04:25
nasioc cu oldun basımıza :D

grkm
27-06-2007, 10:42
ellerine sağlık tolga abim.baya iyi bir setup'ı var.1600cc benzin pompası enjektörüne de kısaca "oha" demek istiyorum.gerçi siteden bir arkadaşımızda da var ama :P

genelde yarış tipi hazırlanmış subaru'larda Hydra EMS kullanıldığı dikkatimi çekti.
Acaba üzerinde Apexi Power FC'den veya Motec'ten daha fazla oynanabilitesi olduğu için mi yoksa ikisine göre fiyatı daha makul olduğu için mi?

biri $unu ingilizceye çevirebilir mi :D

http://www.siamsubaru.com/board/index.php?topic=6153.msg38251

B!Rtan
27-06-2007, 11:31
oy oyy oyyy

Berent.t
27-06-2007, 18:51
ööeeeaaahhhh çok güzelll :):):)

efe-E
27-06-2007, 22:16
biri $unu ingilizceye çevirebilir mi :D

http://www.siamsubaru.com/board/index.php?topic=6153.msg38251

keşke be conem...neyce olduunu bi anlasam belki internetten ufak ufak çeviririz ama.neyce bu?? :D

cem
27-06-2007, 22:25
neyce olduunu bi anlasam belki internetten ufak ufak çeviririz ama.neyce bu?? :D

Thai alfabesi bu .


http://www.omniglot.com/images/writing/thai_cons.gif


Cevirin yardımcı olur :eek:

emreekin
27-06-2007, 22:57
adam sorumlu yaaaaaa..hemen bulmuş nece olduugunu...kanka isveçcemi ögrensek....:D :D :D :D :D :D :D