User Tag List

Toplam 2 adet sonuctan sayfa basi 1 ile 2 arasi kadar sonuc gösteriliyor

Konu: Honda Civic P3Y

  1. #1
    Alican - ait Kullanıcı Resmi (Avatar)
    Üyelik
    12.Haziran.2008
    Yaş
    34
    Şehir
    Ankara
    Mesaj
    2,268
    Post Thanks / Like
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)

    Thumbs up Honda Civic P3Y




    ACC - A/C relay
    ACS - A/C switch
    ALTC - Alternator relay, for control purposes, not present on all ECU’s
    ALTF - Alternator switch
    BKSW- Brake switch, for control purposes, not present on all ECU’s
    ECT - Engine coolant temperature
    ELIMA- Electric load detection, not present on all ECU’s
    FANC - Fan relay, for control purposes, not present on all ECU’s
    FLR - Fuel relay
    IACV - Idle air control valve, controls the 3 wire type IACV valve, (N)egative and (P)ositive control
    IAT - Intake air temperature
    IGPLS- Ignition pulses, 1 is always present, 2 can be ignored
    IGP - Battery feed, only active when key is turned
    IGR - Engine speed
    IMO - Checks IMO code of the key and activates FLR if correct
    INJ - Injector, the numbers refer to the pair of cylinders connected (1 is on the side with the belts)
    LG - Ground for battery circuit
    MAP - Manifold absolute pressure
    MIL - Motor indication light, this one gives the control engine light (CEL) signal
    PCS - Control solenoid, this one is for the small black cylindric valve on the back of the IM
    PG - Ground for battery circuit
    PSP. - Power steering switch, not present on all ECU’s
    O2S - Oxygen sensor (lambda sensor) signal
    SCS - Service connector switch, checks if the SCS connector is hot wired (for reading engine error codes)
    SG - Ground for 5V circuit, 1 is for the MAP sensor, 2 is for the other sensors
    STS - Starter switch
    TDC - Top dead centre
    TPS - Throttle position signal
    TXD. - Diagnostic connector, communication signal to the 3 wire connector next to the SCS connector
    VBU - Back up battery feed, always active (unless battery is removed)
    VCC - 5V feed, 1 is for the MAP sensor, 2 is for the other sensors
    VSS - Vehicle speed sensor

  2. #2
    bLackModeL - ait Kullanıcı Resmi (Avatar)
    Üyelik
    11.Eylül.2011
    Yaş
    33
    Şehir
    aKSAraY68
    Mesaj
    3,855
    Post Thanks / Like
    Mentioned
    2 Post(s)
    Tagged
    1 Thread(s)
    güzel site cevirdi ögreniyorumm terimlerii
    facebook: hasan serdar şengül
    instagram: hasan_serdar

Konu Bilgileri

Bu Konuya Gözatan Kullanıcılar

Şu anda 1 kullanıcı bu konuyu görüntülüyor. (0 kayıtlı ve 1 misafir)

Yetkileriniz

  • Konu Acma Yetkiniz Yok
  • Cevap Yazma Yetkiniz Yok
  • Eklenti Yükleme Yetkiniz Yok
  • Mesajınızı Değiştirme Yetkiniz Yok
  •