aem v1 kullanıyorum...yeşil kesik kesik 5 defa yanıp sönüyor..bunun anlamı nedir..? genel bir arızamı..? depom dolu...nette biraz bakındım ama birşey bulamadım..
Printable View
aem v1 kullanıyorum...yeşil kesik kesik 5 defa yanıp sönüyor..bunun anlamı nedir..? genel bir arızamı..? depom dolu...nette biraz bakındım ama birşey bulamadım..
control unıtesınde problem oldugunu gosterır
bır arıza olabılır baglantıları kontrol etmenı onerırım
System Error Checking
Whenever a system error is encountered, the Boost-Safe output is enabled. All errors are
indicated by a flashing sequence of the status LED which can be determined by counting
flashes. Only one error can be counted with the higher priority at the top of this list:
1. Low Fluid indication
Trigger Condition: The fluid level in the water-methanol tank is below the float level.
The status LED will flash a count of one and repeat. The pump driver will continue to drive
the pump. If the level in the tank is enough to supply the pump with fluid, the controller will
function normally. Fluid flow may be lost in this condition.
2. Pump Driver Open
Trigger Condition: Open circuit between pump drive and battery voltage.
The status LED will flash a count of two and repeat. The pump driver will continue to drive
the pump. If the open is repaired the controller will function normally. Fluid flow may be lost
in this condition.
3. Pump Driver Shorted
Trigger Condition: Current exceeding 15A on the driver output.
The status LED will flash a count of three and repeat. The pump driver will turn off to protect
itself and automatically retry every second. If the short is removed the controller will function
normally. Fluid flow is lost in this condition.
4. Battery Voltage Out Of Range
Trigger Condition: Battery voltage is below 8.5V or above 16V.
The status LED will flash a count of four and repeat. The pump driver will turn off to protect
itself and automatically restart when the voltage returns to the normal range. Fluid flow is lost
in this condition.
5. Water-Methanol Controller
Trigger Condition: Water-methanol controller no longer functioning
The status LED will flash a count of five and repeat. The pump driver will turn off to protect
itself and automatically restart when the water-methanol controller works again. Fluid flow is
lost in this condition.
hımm yani bağlantılarda bir sıkıntı yoksa beyin denilen zımbırtıyımı değiştirmek gerekir...meth. su denetleyicisi çalışmıyor diyor, soğuktan donma vs. olabilirmi aceba..? yardım için teşekkürler..