Teşşekür ederim bilgiler için dostum
BMW G20 320i
https://www.youtube.com/c/smokemotion
Çok bir esprisi olan kod değil ama devam yavaş yavaş
Vagcom Lecture 9 | Auto Coming Home | Golf 7 & MQB | VCDS Tweaks | Coding - YouTube
BMW G20 320i
https://www.youtube.com/c/smokemotion
bu kodlamalar sadece golf için mi geçerli yoksa caddy transporter polo için de geçerli mi? gerçekten emeğinize sağlık
BMW G20 320i
https://www.youtube.com/c/smokemotion
Güzel konu olmuş Mehmet emeğine sağlık.Sıkı takipteyim bende.Gaza gelip 17.8 sipariş verdim biraz önce
Bilen arkadaşlarım,
B8'de start stop'u ilk açılışta otomatikten kapalı başlatabiliyormuyuz vcds'te ve hangi versiyonu olmak zorunda
saygılarımla.
66 vatan 06 mekan
beyler selamlar,s3 ve golf r a yay taktıktan sonra süspansıyon calıbrasyon ayarından bahsedılıyor magnetıclı araclar için,bilgisi olan var mı?
Yaptığınız kodlama yani yazılım geliştirme değil size verilen parametreler üzerinden sadece değişiklikler yapıyorsunuz.
Güzel videolar emeğinize sağlık.
Araçtan araca değişmez Can gatewaydaki aracın üniteleri her zaman araç farketmeksizin aynıdır.
Dcc olan araçların dcc ünite ayarları 14. kanaldan yapılır. Basic Settings bölümünden aracın yeni haline göre (sensörlerin okuduğu yeni değerlere göre) dcc sensörleri "learned" edilmelidir.
Wv golf (1j)
Basic Setting
Sensor for Steering Angle (G85)
Prerequisites:
Start the vehicle.
Turn the steering wheel one turn to the right and one turn to the left.
Drive in a short distance straight line on a level surface at a speed not higher than 20 km/h.
If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight.
Ensure that the steering wheel is not moved again.
Keep the engine running and do not switch off the ignition.
System voltage at least 12.0 V.
[Select]
[03 - Brake Electronics]
[Coding-II - 11]
Enter 40168, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 060
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
After a successful basic setting, field 2 should say "OK".
[Done, Go Back]
To make sure the basic setting was succesful, check the sensor again.
[Measuring Blocks - 08]
Group 004
[Go!]
Check field 1, the value has to be between -4.5 and +4.5 °.
[Done, Go Back]
[Close Controller, Go Back - 06]
Saygılar.
Daily Drive : VW Polo 1.6 TDI
Race : Honda Civic TypeR FK2
Şu an 1 kullanıcı var. (0 üye ve 1 konuk)